Everyone looking for an alternative to smoking has to go with the vape devices, from pod systems to mods. There is, however, another side to the story. Mistakes do happen, and a common nightmare is your vape device getting thrown in unintentionally.
You might sometimes feel that you are drowning when you unintentionally drop your vaporiser into water. There can be circumstances where a vaporiser is thrown into water, although unintentionally, because of temporary distraction or an event occurrence. The devices that may have been casually pitched into the liquids, including water end up experiencing water damage.
How to prevent a vaporiser from becoming submerged?
Vapes are no different from other electronic devices in that they have never been good with water. A vaporiser that has been exposed to water damage may require expensive repairs or possibly be rendered completely unusable.
More advanced vape devices and electronics that can easily be damaged, which could short circuit in as little time as a minute under water exposure, include the GEEKBAR Pulse 15000 Puffs and Pod Salt Go 2500 Puffs. This means damage to the device may not be repairable even if just a small amount of water penetrated inside.
Effects on Vaping Performance After Soaking in Water
The performance of a vape device submerged in water can be negatively impacted.First off, there can be a functional impairment that makes it difficult to turn the device on or off, change settings, or turn on the heating element. Water damage caused by internal device components may affect the general working ability of the device.
Steps to take when your vape gets wet
Step 1: Remove the Battery
Remove the device’s battery as soon as feasible. That should be your initial step. This matters since there is a serious safety risk associated with a wet battery and water and electricity don’t mix well. Rather than handling the battery with your bare hands, remove it using gloves or a dry cloth.
Step 2: Drain Extra Water by Wiping
Next, gently remove any extra water from your vaporiser using a clean cloth or paper towel. Inspect minor cracks and crevices more closely for any water leaks.
Step 3:Remove the vaporiser from its assembly.
To be sure there is no moisture left inside your gadget, you have to disassemble it completely.
Step 4: Dry Thoroughly
Now that you have your vaporiser disassembled, gently rub the parts with a paper towel or a dry cloth. Alternatively, use cotton swabs to clean little areas that still contain water droplets.
Step 5: Allow it to Dry
Wait for your vape to air-dry completely before attempting to reassemble if you clean with a cloth. Admittedly, it may look pretty straightforward to simply let your vape air-dry with a hairdryer or spread all the parts out in the sunlight, but do not do this because that might damage.
Step 6: Assemble and test
Re-assemble your vaporiser when dry and give it a go with a fresh battery. Good luck! If all goes to plan, congratulations: your submerged vape is rescued.
You may be able to increase your chances of fixing your vape and protecting against potential harm as you follow these steps in case your device gets wet, but it’s always better to call for professional help if you feel anxious or do not know how to fix the problem yourself.
Conclusion
In order to maintain the longevity and best possible performance out of your vape device (GEEKBAR Pulse 15000 Puffs and pod salt go 2500 puffs), you must take adequate care of it. Mishaps may occur, but you may avoid water logging and other problems by being careful about where you put your vaporiser and how you handle it.
